How to Reset CLI in Packet Tracer 

To reset the CLI (Command Line Interface) in Cisco Packet Tracer, follow these steps:

1. Access the Device:

   - Click on the network device (router, switch, etc.) you want to reset.

2. Open the CLI:

   - Go to the CLI tab of the device.

 

3. Reset the Device:

   - You can reset the device by issuing a reboot command. In the CLI, type the command `reload` and press Enter. This will restart the device and reset the CLI session.

   - Alternatively, if you want to erase the configuration and reset to factory defaults, you can use the command `write erase` or `erase startup-config` followed by `reload`. Note that this will remove all configurations.

4. Confirm the Action:

   - If prompted, confirm the reload or erase action.

5. Reconnect to the CLI:

   - After the device reloads, you'll need to reconnect to the CLI and reconfigure the device as needed.

Make sure to save any important configurations before resetting, as you might lose unsaved changes.

"To Learn More in Details with Graphical Representation 

You Can Follow This Blog Post"

How to Delete Router Configuration in Packet Tracer